User's Manual

D3POS User Reference
12
2.1.4 Suspend mode
1. When you do not use D3 POS for a long time, make your D3 POS go into the suspend
mode for saving power.
2. If you want to restart your D3 POS, press power key.
2.2 Battery
D3 POS uses replaceable 7.4V 1,800mAh Li-ion Cell x2 Li-ion batteries.
If the battery continues to drop to the “ Low Battery Status” , the battery status LED
becomes red and blinks. You need to recharge the battery.
2.2.1 Checking Battery Power
You can check the battery status by using the power applet.
Tap Start > Settings] > Control panel > Power
The power control panel applet displays a battery power gauge.
2.2.2 Very Low Battery Status
To prevent the D3 POS from being discharged completely, your D3 POS will be suspended,
when the battery continues to get low. You need to recharge your battery before the battery
continues to drop.
2.3 Removing and installing the battery
2.3.1 Removing the battery
At first, pull out the hand scrap and then press the battery latch to the above until the battery
is released from the D3 POS, then lift it out.
2.3.2 Installing the battery
Insert the bottom of battery into the sunken place located in battery compartment, and press
the battery latch to the above until the battery is installed completely.
2.4 Battery discharging
Several factors determine the life of your battery such as extreme temperatures, input devices,
and your usage, but generally you can use D3 POS for 6~12hours.
If the D3 POS is not on external power and battery pack is removed, it will enter suspend
mode.
2.5 Recharging the battery
Use the adapter provided from PartnerTech Corporation to recharge your battery.
Caution
Your D3 POS can be damaged, in case of using the adapter that is not provided from
PartnerTech Corporation.
2.5.1 Using the adapter
The charge/operating power can be applied to D3 POS by using DC adapter.
1. Connect the adapter to the power cord.
2. Connect the DC power jack to the D3 POS.
When the battery is charging, the LED becomes red.