User guide

U SER G UIDE
11 / 79
Powering on/off
Device has three different power states: Off, Standby, and On. Below table shows how to
power on/off, enter Standby mode, and wake-up from Standby mode.
Off  On Press Reset pinhole
On  Off Press and hold Reset pinhole for 5 seconds
On  Standby Press Power key
Standby  On Press Power key
Note: The first time you use device, it will be in Off mode.
Reset device
Device has soft reset and hard reset functions, as well as a factory default function.
ATTENTION: Factory default will erase all user files and settings!
Soft reset Press Reset pinhole
Hard reset Press Power key and Reset pinhole at the same time
Factory default Press and hold Power key, and press Reset pinhole. Keep
holding down Power key until message appears on screen to
press the FUN key. Press the FUN key to do Factory Default, or
press Reset to cancel.
Enabling backup battery
Backup battery is used to store Standby mode data when main battery is empty, or is
removed. Backup battery can keep the information for 10 minutes. Charging of the backup
battery is automatically done via AC adaptor, or when main battery is present.
To enable/disable the backup battery:
1) Remove main battery.
2) At the bottom left of the battery slot, there is a switch. Put switch towards the right
side to disable backup battery. Put switch towards the left to enable backup battery.