User's Manual

ENGLISH

WEEE Notice

The WEEE logo on the product or on its box indicates that this product must not be

disposed of or dumped with your other household waste. You are liable to dispose of

all your electronic or electrical waste equipment by relocating over to the specified

collection point for recycling of such hazardous waste. Isolated collection and proper

recovery of your electronic and electrical waste equipment at the time of disposal will

allow us to help conserve natural resources. Moreover, proper recycling of the

electronic and electrical waste equipment will ensure safety of human health and

environment. For more information about electronic and electrical waste equipment

disposal, recovery, and collection points, please contact your local city center,

household waste disposal service, shop from where you purchased the equipment, or

manufacturer of the equipment.

FCC Regulations

15.19(a)(3):

This device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference, and (2)

this device must accept any interference received, including interference that may

cause undesired operation.

15.105(b):

NOTE: This equipment has been tested and found to comply with the limits for a Class

B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

• Consult the dealer or an experienced radio/ TV technician for help

Changes or modifications not expressly approved by the party responsible for

compliance could void the user‘s authority to operate the equipment.