User's Manual

Installation – Speakers
Page | 14
Connecting speakers to the DAX88 in BRIDGE MODE
In BRIDGE mode the amplifier LEFT and RIGHT outputs are combined into a more
powerful MONO output, thus doubling the output power to 50 watts with a minimum
speaker load of 8 ohms. Remove approximately 5 inches from the cable jacket, strip
1/4" of insulation from the speaker wire, and twist the copper strands. Insert the speaker
wires into the connector per the label below the output terminals and tighten the set
screws. Repeat for the remaining zones. It is permissible to mix STEREO and Bridged
MONO outputs on one DAX88.
-+
8 ohm speaker
MONO
Set the MODE switch to BRIDGE