Installation Guide

©2018 The Agency ACBH. PO Box 178, West Grove, PA 19390
www.partsmasterpro.com
1-877-542-2211
[e-mail]
53007
53007
©2018 The Agency ACBH. PO Box 178,
West Grove, PA 19390. All Rights Reserved.
The Agency ACBH assumes no responsibility
for failure due to improper use. PartsmasterPro
is a registered trademark of The Agency ACBH
www.partsmasterpro.com
Made in Taiwan
Security Device Enclosed
Does not fit with Delta Waterfall model faucets.
Attach Hose to Spray Head
Attach Hose to Faucet
1. Screw quick connect adapter(1) onto hose.
2. Attach adapter(2) to male threaded connection.
3. Push quick connect adapter(1) onto adapter(2) while pulling down the white ring.
1. Screw quick connect adapter(1) onto hose.
2. Attach adapter(2) to female threaded connection.
3. Push quick connect adapter(1) onto adapter(2) while pulling down the white ring.
1. Screw quick connect adapter(1) onto hose.
2. Insert adapter(2) into diverter clip.
3. Push quick connect adapter(1) onto adapter(2) while pulling down the white ring.
1. Screw quick connect adapter(1) onto hose.
2. Push quick connect adapter(1) onto adapter(2) while pulling down the white ring.
1. Be sure hose is not entangled with water supply lines or drain.
2. Remove weight from old hose and transfer to proper location on new hose.
3. Turn on water supply and check for leaks.
1. Turn off water supply. Measure location of weight on old hose.
2. Measure location of weight on old hose. Mark weight location on new hose.
3. Remove old hose.
4. Slide ferrule nut(4) over hose end.
5. Tighten adapter(3) onto hose end.
6. Place washer(2) onto ferrule nut(4).
7. Screw ferrule nut(4) onto spray(1).
Match faucet connection type to B-1, B-2, B-3 or B-4.
WARNING: Cancer - www.P65warnings.ca.gov
Installation Instructions