Installation Guide

©2018 The Agency ACBH. PO Box 178, West Grove, PA 19390
www.partsmasterpro.com
1-877-542-2211
[e-mail]
58405
1. Turn off water supply to sink.
2. Measure location of weight on old hose. Mark weight location on new hose.
3. Use adjustable wrench to unthread nut on old spray head.
4. Use adjustable wrench to unthread hose from underside of faucet.
5. Several adaptors are included, locate adaptor that properly threads onto spray head and attach hose end.
6. Thread new spray hose through faucet spout.
7. Locate proper adaptor to thread onto connector on underside of faucet. Attach hose end to underside of faucet.
Note: Be sure that hose is not entangled with water supply lines or drain.
8. Remove weight from old hose and transfer to proper location on new hose.
Pullout Spray Head
Security Device Enclosed
©2018 The Agency ACBH. PO Box 178,
West Grove, PA 19390. All Rights Reserved.
The Agency ACBH assumes no responsibility
for failure due to improper use. PartsmasterPro
is a registered trademark of The Agency ACBH
www.partsmasterpro.com
Made in Taiwan
Does not fit with faucets that use a quick-connect hose connection to the faucet.
WARNING: Cancer and Reproductive Harm - www.P65warnings.ca.gov
Installation Instructions