Installation Guide

www.partsmasterpro.com

1-877-542-2211

customerservice@theonlyagencyrep.com

58530

1. Turn off water supply.

2. Remove retaining screw from handle.

3. Remove handle by pulling straight out.

4. Unthread retaining screw from flange and remove flange.

5. Unthread sleeve and remove sleeve.

6. Using the included shower valve socket wrench,

unscrew and pull out stem.

7. Insert seat wrench into faucet, turn counter-clockwise and remove old seat.

8. Place new seat into faucet and tighten with seat wrench. Using the included

shower valve socket wrench, install new stem, ensuring washer is in place

under the stem bonnet.

9. Thread sleeve onto stem. Slide flange over sleeve and place flush against the

wall. Tighten retaining screw.

10.Place new handle on stem and tighten with retaining screw.

11.Turn on water supply and check for leaks.

Installation Instructions

PAGE 1
-877-542-2211 customerservice@theonlyagencyrep.com 58530 Installation Instructions 1. 2. 3. 4. 5. 6. Turn off water supply. Remove retaining screw from handle. Remove handle by pulling straight out. Unthread retaining screw from flange and remove flange. Unthread sleeve and remove sleeve. Using the included shower valve socket wrench, unscrew and pull out stem. 7. Insert seat wrench into faucet, turn counter-clockwise and remove old seat. 8. Place new seat into faucet and tighten with seat wrench.