User's Manual

Energy Transfer - Wind Turbine Model No. ET-8783
2
Introduction
The Energy Transfer - Wind Turbine accessory can be attached to the
Energy Transfer Generator (ET-8771) to create a wind energy turbine.
Equipment Setup
Energy Transfer-Wind Turbine Assembly
1. Remove the thumb nut and pulley from the Energy Transfer Generator.
Do not discard these components. Retain for other use.
2. Place spacer over plastic shaft of the Energy Transfer-Generator.
3. Place 5-blade fan over same plastic shaft of Energy Transfer
Generator.
4. Note orientation of 5-blade fan. See Figure 1.
5. Secure 5-blade fan with thumbnut. Do not over tighten.
Figure 1: Wind Turbine Assembly
ET-8771
(not included)
spacer
5-blade fan
thumbnut
do not
discard