User's Manual

Instruction Sheet
012-13897A
SPARKlink Air Charging Station
PS-2577
800-772-8700 www.pasco.com
Introduction
The PASCO model PS-2577 SPARK Charging Station is
designed to work with a PASCO PS-2011 SPARKlink Air. The
Charging Station can hold up to five SPARKlink Air’s at one
time. It takes approximately five hours to fully charge five SPAR-
Klink Air’s.
The SPARKlink Air Charging Station includes a 20 watt switch-
ing power adapter (100 - 240 VAC input and 5 VDC, 4.0 A out-
put).
Operation
Connect the plug from the power adapter to the power input jack
on the Charging Station. The power input jack is at the midpoint
on the upper left edge of the station. Connect the power cord
from the power adapter to a compatible electrical receptacle.
Make sure that the SPARKlink Air is OFF before inserting it into
one of the slots of the Charging Station. Insert as many as five
SPARKlink Air Systems. Because the Charging Station has a
fixed regulated power suppy, it does not matter how many of the
five slots are filled with SPARKlink Air Systems.
As the SPARKlink Air is charging, the light emitting diode
(LED) on the top right hand end of the SPARKlink Air will flash
red. When the SPARKlink Air is fully charged, the LED will
shine green continuously. The SPARKlink Air’s charging cir-
cuitry will disconnect itself from the battery when fully charged.
SPARKlink Air Charging Station
Power Input Jack