User Manual

Instruction Sheet

012-05835B

800-772-8700 www.pasco.com

Force Accessory Bracket

CI-6545

Introduction

Use the CI-6545 Force Accessory Bracket to mount a force sen-

sor on a PASCO track. The included bumpers can be attached to

the force sensor or directly to the bracket for collisions with a

cart.

Figure 1: Large force sensor attachment

Figure 2: Small force sensor attachment

Included Equipment Replacement Parts

1. Bracket CI-6545

2. Screwdriver 855-005

3. Square Nuts (4 pieces)

ME-9823 (IDS Spares Kit)

4. T-screws for mounting

on track (4 pieces)

5. Thumb screws for

attaching force sensor

(2 pieces)

6. Magnetic Bumper ME-9885A (set of 2)

7. Rubber Bumper CI-6463

(Force Sensor Spares Kit)

8. Light Spring Bumper

ME-9884

(Bumper Accessory Set)

9. Heavy Spring Bumper

10. Clay Holder

11. Clay

Force Sensor

Thumbscrews

Tare button

access

Force Sensor

Thumbscrew

89 10

PAGE 1
I n s tr u c t i o n S he e t ® 012-05835B Force Accessory Bracket CI-6545 1 2 3 4 Introduction 5 Use the CI-6545 Force Accessory Bracket to mount a force sensor on a PASCO track. The included bumpers can be attached to the force sensor or directly to the bracket for collisions with a cart. 6 Thumbscrews 7 11 8 9 10 Included Equipment Replacement Parts 1. Bracket CI-6545 2. Screwdriver 855-005 Force Sensor Figure 1: Large force sensor attachment 3. Square Nuts (4 pieces) 4.
PAGE 2
Fo r c e A c c e s s o r y B r a c k e t C I- 6 5 4 5 Recommended Equipment Force Sensor Cart T Track E AR The Bracket is designed for use with PASCO dynamics tracks and all types of PASCO carts and force sensors. The table below is a partial list of compatible equipment.
PAGE 3
Fo r c e A c c e s s o r y B r a c k e t C I- 6 5 4 5 Magnetic Bumper The magnetic bumper can be used for elastic collisions. For example, if the force sensor is mounted on the bracket in the low position, and the magnetic bumper is attached to the force sensor, the bumper will repel a dynamics cart that has magnets in its end cap. The magnetic bumper has a small pin next to the screw.