User Manual

Instruction Sheet
for the PASCO
Model PS-2525
Adhesive Mylar Foam Covers (10 Pack)
012-08767A
Introduction
The Adhesive Mylar Foam Covers (PS-2525) are
replacement units for use with the Fast Response
Temperature Probe (PS-2135). The adhesive disks
are designed to hold the temperature probe tip and
adhere it to a participant’s skin or to other flat
surfaces. The mylar reduces environmental
influences.
Using the Adhesive Mylar Cover
1. Remove one of the adhesive mylar foam cover
disks from the sheet set.
2. Carefully remove the protective backing paper.
3. Place the Fast Response Temperature Probe
sensing tip in the center of the disk adhesive.
4. Place the adhesive mylar foam disk on a smooth
(preferably hairless) skin surface