Brochure

Shower Pan Liner
Shower Pan Liner-10
3/25/18
GANG SHOWER INSTALLATION
Shower areas with multiple shower heads and drains are
commonly referred to as “gang showers”. These shower
areas are found in schools, dormitories, sports facilities and
commercial installations.
Read the previous instructions in this brochure and pay
particular attention to the corner, drain and seaming details
(see Figures 1 through 11).
When large areas must be covered, PASCO Vinyl Shower
Pan Liner can be easily joined. Sections of the liner can be
joined as they are laid. Lay sections to be joined, side by side
and follow the instructions for joining as explained in Figures 9
through 11.
If metal studs are present, proceed as follows. The
shower pan material must be attached at the height of
at least three inches above the highest flood level of the
shower area. Determine this height and attach a metal
furring strip at this level around the entire shower stall
area.
Measure the shower area, determine the amount of
material required and also determine where seams will
be required. To attach the shower pan material to the
metal furring strip, fold the material as indicated in Figure
12. Use a small diameter, short length, self tapping sheet
metal screw with a small washer to fasten the material to
the metal furring strip. Space screws at a distance which
will prevent the material from sagging.
Finish the drain installation as described in Figure 7 and
perform appropriate water test as described in installation
section # 3.
Figure 12