Use and Care Manual

Precision Placement Driving - (Orange Trigger)
■Grasp the tool handle firmly and hold the bottom of the work
contacting element firmly against the workpiece until it is com-
pletely depressed.
■Squeeze the trigger to drive the fastener.
■Lift the tool from the workpiece.
■Repeat the procedure for the next fastener.
Successive (Bounce) Driving - (Orange Trigger)
■Grasp the handle firmly.
■Squeeze the trigger and move the tool along the workpiece
with a bouncing motion, depressing the work contacting element
at the points where you want to insert a fastener.
■Keep the trigger depressed and continue to bounce the work
contacing element against the workpiece, positioning the tool
above as carefully as possible.
■When the desired number of fasteners have been driven,
release the tool trigger to avoid unintentional fastener discharge.
Sequential Operation - (Silver Trigger)
The sequential operating kit prevents succesive or "bounce"
driving.
■Depress the work contacting element and hold it against the
work surface before pulling the trigger.
■After each fastener is driven, completely release the trigger
and lift the tool from the work surface.
TOOL OPERATION -
continued
➔
➔
SOCKET HEAD
CAPSCREW
WORK
CONTACTING
ELEMENT
MOVE UP
TO INCREASE
DRIVE DEPTH
MOVE DOWN
TO DECREASE
DRIVE DEPTH
6
Clearing a Jam
An occasional problem you may encounter is a
jammed fastener. Because of the unique design
of the tool, clearing a jammed fastener is easy:
1. Disconnect the air supply.
2. Pull the latch, releasing front guide. Pivot
front guide forward.
3. Clear jam, and push driver blade back up to
its normal position.
4. Close front guide and latch it. Check that
work contacting element moves freely.
Turn
adjustment
wheel in either
direction
clearing a jam continued