Use and Care Manual

4
An Overview of the Paslode Cordless Framing Nailer
Description
The Paslode Cordless Framing Nailer is a self-contained,
fully portable nailer that uses liquid hydrocarbon fuel to
power a unique linear drive internal combustion motor.
As with any internal combustion motor, the Paslode Cordless
Nailer will require periodic maintenance to keep it operating
at it's peak performance. The cleaning procedure booklet
will instruct you on the proper cleaning of your tool. If
additional services are required, contact your local Paslode
service provider.
Specifications
Dimensions: Weight (with battery) 7.2 pounds (3.2 Kg)
Height 14-1/2 inches (368mm)
Length 12 inches (305mm)
Cycle Rate: Intermittent Operation – 2 to 3 nails/second
Maximum Cycle Rate: 1,000 shots per hour
NOTE: Exceeding these rates could cause tool to overheat,
resulting in loss of performance or damage to tool
components.
By using the Paslode Cordless Framing Nailer at its
recommended cycle rate, you will be able to drive several
thousand nails in a typical workday.
Fasteners: 30° paper tape collation
Minimum 2 inch x .113 dia. shank (50 x 2.87mm)
Maximum 3-1/4 inch x .131dia.shank (90 x 3.15mm)
Magazine Capacity: 1 nail strip + 5 fasteners.
Battery : 7.4 volts DC - Provides enough energy to
drive approximately 9000 fasteners on a full
charge.
Fuel Cell: Paslode Framing Fuel Cell. Liquid hydrocarbon-
Provides enough fuel to drive approximately
1200 fasteners.
Cover and Filter
Motor Housing
MOTOR ASSEMBLY
Adjustable
Work-Contacting
Element
Follower
Channel magazine
HANDLE ASSEMBLY
Battery
Compartment
(Opposite Side)
Battery
Indicator Light (LED)
Fuel Cartridge Compartment
Utility Hook
Toe Nailing Teeth
NOTE: Altitude Restriction
Paslode Cordless tools are powered by an internal
combustion engine and are effected by altitude. The
tool may lose power or not cycle consistantly at
elevations of 6000 feet (1,828 meters) or greater.
Trigger