Use and Care Manual

6
Precision Placement Driving
■ Grasp the tool handle firmly and place the bottom of the
work contacting element firmly against the workpiece until
it is completely depressed.
■ Squeeze the trigger to drive the fastener.
■ Lift the tool from the workpiece.
■ Repeat the procedure for the next fastener.
Successive (Bounce) Driving
■ Grasp the handle firmly.
■ Squeeze the trigger and move the tool along the work-
piece with a bouncing motion, depressing the work contacting
element at the points where you want to insert a fastener.
■ Keep the trigger depressed and continue to bounce the
work contacing element against the workpiece, positioning
the tool above as carefully as possible.
■ When the desired number of fasteners have been driven,
release the tool trigger to avoid unintentional fastener discharge.
TOOL OPERATION -
continued
Loading of Nails
Step 1 - Grasp the handle firmly.
Step 2 - Insert one or two strips of nails into the rear
of the magazine.
Step 3 - Pull the follower to the rear of the magazine
until it is engaged behind the nails.
The tool is manufactured with a (Silver) sequential
trigger installed.
Sequential Operation - (Silver Trigger)
The sequential operating trigger prevents successive
or “bounce” driving.
■ Depress the work contacting element and hold it
against the work surface before pulling the trigger.
■ After each fastener is driven, completely release
the trigger and lift the tool from the work surface.
Grommet
Trigger Pin
Sequential Lever
Sequential
Trigger
Sequential
Actuator
#501039
Contact Trip (Bounce) Trigger Operation
(Orange Trigger)
Grommet
Trigger Pin
Bottom Trip Lever
Contact
Trigger
The trigger kit (#501048) allows successive or
“bounce” driving.
#501048
WARNING
Do not clamp or hold the trigger with
anything other than your hand.