Operators Manual

[e-mail]
www.itwcp.co.uk
Technical Helpline UK: 0800 731 4924
Technical Helpline ROI: 1 800 882 388
11
Inserting Fuel Cell
Inserting the metering valve/fuel cell assembly into the
Cordless Stapler is very simple. To begin, press up at the
bottom of the actuator cover and pivot outward to open. The
cover will swing out of the way.
Next, with the metering valve stem pointed toward the front
of the tool, insert the metering valve/fuel cell assembly.
As you slide the metering valve/fuel cell assembly into the
Cordless Stapler, you will notice a
yellow adapter at the top
of the cylinder pocket. As shown in the illustration, this
adapter is designed to ensure that the metering valve stem
is properly aligned with the small hole, or orifice, that leads
to the combustion chamber. Insert the metering valve stem
into the orifice of the
yellow-colored adapter.
Fuel Cell and Metering Valve
Close the actuator cover to complete the loading of fuel in
the Cordless Stapler. Do this by swinging it up and over the
fuel valve/cylinder assembly, and pushing down until the
actuator cover snaps into position.
1. PRESS UP
2. PULL OUT
1. SWING UP
2. PUSH DOWN
IM200 S16 Operator Manual
12/20