Operators Manual

[e-mail]
www.itwcp.co.uk
Technical Helpline UK: 0800 731 4924
Technical Helpline ROI: 1 800 882 388
2
Introduction and Warranty
Cordless Stapler Operating Manual
This manual is intended to acquaint you with the Paslode
Cordless Stapler. Unlike other power fastening tools, the
Cordless Stapler is powered by an internal combustion
linear motor. In simpler terms, your Cordless Stapler is
powered by a motor similar to the one that powers an
automobile. The Cordless Stapler ignites a fuel and air
mixture to produce the energy to drive the motor, which in
turn drives the fastener. As you will see, the Cordless
Stapler is totally self-contained. It carries its own fuel supply
and battery, along with a supply of fasteners.
For ease of use, this manual is divided into sections (see
Contents). Each section of the manual is written with you,
the tool operator, in mind. We have left out all of the technical
terms so that you can readily understand how to get the
maximum performance from your Cordless Stapler, and
how to avoid damaging the tool or injuring yourself. But, to
accomplish this, we need you to do two things:
1. READ THE MANUAL FROM COVER TO COVER
BEFORE USING THE TOOL.
2. FOLLOW ALL INSTRUCTIONS IN THE MANUAL.
The Cordless Stapler should be handled like other power
fastening tools that you use. Like most tools, when used
improperly it could result in injury. If you are going to allow
others to use the Cordless Stapler, it is your responsibility
to make sure that they also read and comply with the
instructions in this manual before attempting to operate
the tool.
Should you have questions about the Cordless Stapler ,
or wish to obtain additional copies of this manual, please
contact your Paslode
®
representative. The space below is
provided so that you may record your representative's
name, address, and telephone number.
My Paslode representative is:
Name
Address
City State Zip
Telephone Number
Impulse
®
Warranty and Limitations
Paslode warranty that new Cordless power fastening tools, parts
and accessories will be free from defects in material and
workmanship for the period shown below, after the date of
delivery to the original user.
ONE-YEAR LIMITED WARRANTY
A one-year warranty will apply to all parts, except those listed
below as normal wearing parts, or parts which are specifically
covered by an extended warranty.
FIVE-YEAR EXTENDED LIMITED WARRANTY
A five-year warranty will apply to all molded nylon parts:
• Motor Housing, Cap and Grille
• Handle Halves and Actuator
• Trigger
90-DAY LIMITED WARRANTY
A 90-day warranty applies to the following parts, which are
considered normal wear parts:
• Bumper
• Driver Blades
• O-Rings
• Piston Rings
WARRANTY STATEMENT
Paslode's sole liability hereunder will be to replace any part or accessory
which proves to be defective within the specific time period. Any replacement
part or accessory provided in accordance with this warranty will carry a
warranty for the balance of the period of warranty applicable to the part it
replaces. This warranty does not apply to part replacement required due
to normal wear.
This warranty is void on any tool which has been subjected to misuse,
abuse, accidental or intentional damage, use with fasteners, fuel, batteries,
or battery chargers not meeting Paslode specification, size, or quantity,
improperly maintained, repaired with other than genuine Paslode
replacement parts, damaged in transit or handling, or which, in Paslode's
opinion, has been altered or repaired in a way that affects or detracts from
the performance of the tool.
PASLODE MAKES NO WARRANTY, EXPRESSED OR IMPLIED,
RELATING TO MERCHANTABILITY, FITNESS, OR OTHERWISE,
EXCEPT AS STATED ABOVE, and Paslode's liability AS STATED ABOVE
AND AS ASSUMED ABOVE is in lieu of all other warranties arising out of,
or in connection with, the use and performance of the tool, except to the
extent other wise provided by applicable law. PASLODE SHALL IN NO
EVENT BE LIABLE FOR ANY DIRECT, INDIRECT, OR CONSEQUENTIAL
DAMAGES, INCLUDING, BUT NOT LIMITED TO, DAMAGES WHICH
MAY ARISE FROM LOSS OF ANTICIPATED PROFITS OR
PRODUCTION, SPOILAGE OF MATERIALS,, INCREASED COST OF
OPERATION, OR OTHERWISE.
Paslode reserves the right to change specifications, equipment, or designs
IM200 S16 Operator Manual
3/20