Operators Manual

[e-mail]
www.itwcp.co.uk
Technical Helpline UK: 0800 731 4924
Technical Helpline ROI: 1 800 882 388
3
Description
The Cordless Stapler is a self-contained, fully portable tool
that uses liquid hydrocarbon fuel to power a unique linear
drive internal combustion motor.
In order for you to fully understand the information contained
in this manual, you need a basic understanding of the
Cordless Stapler. As you can see in the illustration below,
the Cordless Stapler is made up of three separable
assemblies: handle, motor and rail.
As you examine the Cordless Stapler, become familiar with
the three major assemblies and the various components
located in each of them.
The Handle Assembly contains the fuel cell, the battery
indicator light, and the trigger.
The Motor Assembly contains the cover and filter, the
motor housing, the nose, and the work contacting element.
The Rail Assembly contains the components to load and
control the specfic fastener for the Impulse Stapler.
Specifications
Dimensions: Weight 6.5 lbs.
Height 12-1/2 nches
Length 13-1/2 inches
Cycle Rate: Intermittent Operation – 2 to 3 staples
per second
Continuous Operation – 500 staples
per hour
NOTE: Exceeding these rates could cause tool to overheat,
resulting in loss of performance or damage to tool
components.
By using the Cordless Stapler at its recommended cycle
rate, you will be able to drive several thousand nails in a
typical workday.
Fasteners: 16 gauge, Std. Crown Staples
Rail Capacity: 2 strips, or 150 fasteners
Battery : 6 volts DC - Provides enough energy to
drive approximately 4000 fasteners on a full
charge.
Fuel Cell: Liquid hydrocarbon - Provides enough fuel
to drive approximately 2400 fasteners.
An Overview of the Cordless Stapler
belt hook
Rail Assembly
fuel cell compartment
motor housing
cap
cover & filter
Adjustable
guide
Handle Assembly
trigger
Motor Assembly
battery compartment
(opposite side)
battery indicator light
(opposite side)
follower
Quick Clear
IM200 S16 Operator Manual
4/20