Manual

Fuel Cell and Metering Valve
Inserting Fuel Cell
Inserting the metering valve/fuel cell assembly into the
TrimMaster 18TM Finish Nailer is very simple. To begin,
press up at the bottom of the actuator cover and pivot
outward to open. The cover will swing out of the way.
m,_2. PULL OUT
j _ 1. PRESS UP
Next, withthe metering valve stem pointedtowardthe front
of the tool, insert the metering valve/fuel cell assembly.
As you slide the meteringvalve/fuel cell assemblyintothe
TnmMaster 18" Finish Nailer, you will notice a yellow
adapter at the top of the cylinder pocket. As shown in the
illustration, this adapter is designed to ensure that the
metering valve stem is property aligned with the small hole,
or orifice, that leadsto the combustion chamber. Insert the
metering valve stem into the orifice of the ely---colored
adapter.
Yellow
Adapter Cell
Yellow Meterim
Valve
ig Valve Stem
Close the actuator cover to complete the loading of fuel in
the TrimMaster 18"Finish Nailer. Do this by swinging it up
and over the fuel valve/cylinder assembly, and pushing
down until the actuator cover snaps into position.
2. PUSHDOWN
q_ 1.SWING BACK
11