Manual

ManualsBrandsPaslode ManualsPower ToolOfficial Paslode cordless finish nailer

Troubleshooting

Normal Stage of Operation

SYMPTOM

Tool operates properly,but fasteners do net

ddve fully.

POSSIBLE PROBLEMS

Work-contacting element requires adjustment.

Fuel cell is low.

There may be less of seal in combustion

chamber.

SERVICE

Adjustwork contacting element.

Check fuel cell and replace as required.

Presswork contacting element against

workpiece for one minute. Pull trigger. If

fastener does notdrive, there isa leak that

requires service.

Tool operates propady, but fasteners are Work-contacting element is not adjusted Adjust werk-confacting element. Readjust

som_imes over-ddven, and sometimes propedy for the type of matadal being as requiredwhen matedal density or

under-driven, fastened, thicknessof matadal being fastened

changes.

Tool operates, but no fastener is driven. Wrong fasteners being used.

Followernet propedy engaged behind fastener

stdp.

Jammed fastener.

Fuel cell is low.

Spark plug wire isloose.

Air filter is dirty,causing toolto overheat.

Tool operates erraticallyor appears tobe

losing power - tool indicator light is green.

Tool eperated and drove fasteners, but

ddver blade did not returnto up position.

Tool is dirty.

Built-updirtand debds on ddver blade or in

nose bore.

Use only fasteners meeting Paslede®

specifications.Check Fasteners and

Applicationssection for fastener types and

sizes recommended for use inImpulse tool.

Positionfollower behindfastener stdp and

engage stdp.

Clear jam.

Checkfuel cell.

Check spark plug wire.

Remove air filter and clean. Use soap and

water to remove stubborn debris.

Clean tool.

Clean ddver blade and nose bore with

degreaser cleaner.

Tool isdirty. Clean tool.

Clean trackor replace work-contacting

Combustionchamber does not drop after Work-contactingelement is bent, or isdirty, element.

toolcycles.

If nailer will not operate after following the above service directions, return the tool to an authorized Paslode ®

representative for service.

For the nearest Paslode ®representative call 1-800-682-3428.

For Technical support call 1-800-222-6990.

888 Forest Edge Drive

Vernon Hills,Illinois 60061