Manual

Battery and Charging System
Inserting Battery
1. Loadthe battery, contacts first, into the TrimMaster 18TM
Finish nailer.
2. Push battery fully forward into its locked position.
3. To remove battery, push down on locking tab and slide
battery out.
NOTE: If battery is left in tool for an extended period, the
batterywilldischargecompletelyandwillrequire recharging.
IMPORTANT: Should your battery terminals become
corroded and cause poor electrical contact, clean the
terminalsusinga softcloth.
Cleanthe
Battery Indicator Light
On the rightside of the handle is a smallplastic lens. This
is the battery indicator light. When you insert afully-charged
battery into the tool, you will see a blinking green light. Ifthe
indicator light blinks red, recharge the battery.
BATTERY INDICATOR LIGHT
/