User manual

INT-30A Owners Manual

Choose either XLR or RCA inputs. If you run both at once on a single

input from different components, the sound is not likely to be optimal, but

it shouldn’t cause damage anywhere.

Now that the source components and loudspeakers are connected into

the amplifier; plug the power cord back into the wall, and turn on the rear

power switch.

Push the front panel power button to activate the amplifier and turn the

volume control down (counter clock-wise). The front panel display should

now be illuminated.

The controls on the front of the Pass Labs integrated amplifier should be

intuitive. You should however understand that the volume control is always

active and over rides the mute control. Meaning that if at some point you

activate the mute control you can un-mute the amplifier by either pushing

the mute control a second time or by either advancing or retarding the

volume control knob.

The hand remote has some additional convenience features that the front

panel does not. Balance from the remote raises or lowers the speaker

volume levels relative to each other. Display provides a choice of normal

luminance, reduced luminance or display off. In the display “off ” mode

the display will be normally dark, yet will provide reduced luminance

for several seconds any time a control function on either the remote or

integrated amplifier front panel are activated.

Please note: The hand remote is common to several Pass Labs products,

not all of the functions on this remote are applicable to your integrated

amplifier. Input 5, tape loop, pass through and external amp on are not

applicable to the INT-30A, integrated amplifier.

The hand remote has two (2) AAA batteries that can be replaced after the

back cover from the remote has been removed. These batteries will need

to be changed occasionally.

If you are not comfortable removing the rear cover of the remote and

changing batteries, have your dealer change them for you. Batteries may

explode if exposed to excessive heat, never leave your remote or any

battery powered device in direct sunlight or exposed to excessive heat

sources.

With any luck, you can now enter that blissful state of musical nirvana, and

we won’t expect you back for a while.

It’s always possible that something may go wrong. If so, don’t get excited.

We know It’s really aggravating when a product doesn’t work, but it will get

fixed, and often it’s something really simple.

You are ready to play music