Installation Manual

Page 18
301 Fulling Mill Road, Suite G ©Copyright 2008 by On-Q/Legrand,
Middletown, PA 17057 Inc All Rights Reserved.
(800)-321-2343 www.onqlegrand.com
Firmware Info
The Firmware Info option, selected from the Installer Setup screen (see Figure 46) is an option
screen that displays the Unit Name, firmware revision and address of that particular Room Unit
(see Figure 47). This information may be very handy if the installer is troubleshooting a
problem over the phone with On-Q Technical Support.
System Reset
The System Reset option, selected from the Installer Setup screen (see Figure 48) performs a
total system reset, which takes all Units back to factory settings (see Table 4). When you select
System Reset (see Figure 49) and press talk/select, a Warning screen (see Figure 50)
appears briefly to remind you that you are going to erase all names and settings. Then you are
asked to hold the Volume plus (+) and Volume minus (-) keys down at the same time to perform
the reset (see Figure 51). Shortly after you release those Volume keys, you should see a
screen similar to the one shown in Figure 52 and once the system has finished its reset, a
Room Unit screen similar to the one shown in Figure 53 will be seen.
FIRMWARE INFO
Unit Name:
Address: 90:1040
Rev: v1.0rc2.28
BACK
ROOM 4
FIRMWARE INFO
Unit Name:
Address: 90:1040
Rev: v1.0rc2.28
BACK
ROOM 4
ROOM1
INSTALLER SETUP
Reply Options
Door Options
Firmware Info
System Reset
Room Options
Disc. Settings
ROOM1
INSTALLER SETUP
Reply Options
Door Options
Firmware Info
System Reset
Room Options
Disc. Settings
SYSTEM RESET
SYSTEM RESET
BACK
To Reset:
Hold VOL+ & VOL-
SYSTEM RESET
SYSTEM RESET
BACK
To Reset:
Hold VOL+ & VOL-
Rev v1.0cr2.28
ROOM 1
Discovering…
My Address:
90: 1040
My Name:
Rev v1.0cr2.28
ROOM 1
Discovering…
My Address:
90: 1040
My Name:
Figure 48
ROOM1
INSTALLER SETUP
Reply Options
Door Options
Firmware Info
System Reset
Room Options
Disc. Settings
ROOM1
INSTALLER SETUP
Reply Options
Door Options
Firmware Info
System Reset
Room Options
Disc. Settings
SYSTEM RESET
SYSTEM RESET
BACK
SYSTEM RESET
SYSTEM RESET
BACK
SYSTEM RESET
SYSTEM RESET
BACK
=WARNING=
All names and
settings will
be erased!
=WARNING=
All names and
settings will
be erased!
SYSTEM RESET
SYSTEM RESET
BACK
=WARNING=
All names and
settings will
be erased!
=WARNING=
All names and
settings will
be erased!
Figure 49
Figure 50 Figure 51
Figure 52
ROOM1
ROOM2
ALL
PATIO1
SETTINGS
DOOR1
ROOM1
ROOM2
ALL
PATIO1
SETTINGS
DOOR1
Figure 53
Figure 46
Figure 47