User Manual

English

Installation of the Wireless Desktop

Make sure that your computer is powered off before plugging the receiver into the PS/2 mouse

and keyboard ports located in the rear of your computer. Install the included batteries into the mouse and

keyboard before turning on the system. Depending on your operating system you may be prompted to insert

the driver disk into computer’s drive. Insert the included driver disk and follow the on-screen instructions.

Connect Devices

If you find that you are having problems with your mouse or keyboard (erratic or no movement), simply

pressing the "connect" key on the receiver then press the "reset" key on th bottom of the mouse or

Keyboard.

Low Battery Lights

If the light in the front of the mouse or the top left of the keyboard does not go on when you move

the mouse or press a key, the voltage of the battery is low. Please replace your batteries. Expected battery

life is 2 to 6 months depending on usage.

Driver & Utilities Installation

The utilities program can be used to install the mouse and keyboard customization driver, this adds

additional programmability to your mouse buttons and the multimedia keys of the keyboard.

After the proper installation of the hardware, insert the program driver disk into the disk drive, and double

click on the “SETUP” icon to start the installation. Follow the on screen prompts to finish the installation,

which may or may not ask you to restart your computer (dependent on your operating system).

Labtec

Wireless Mouse Utility Program

The utility program uses your normal “Mouse Control Panel”. This addition adds two sets of tabs

to the menus (“Wheel” and Buttons”). For additional help with all “Mouse Control Panel” items use the help

buttons located in the menus.

Scrolling Functions

These controls enable and disable smooth scrolling and the number of lines to scroll at a time.

See the details button for more information.