User Manual

E n g lis h

Note

Federal Communications Commission

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) this device may not cause harmful interference , and (2) this device must accept any interference

received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital devic , pursuant

to Part 15 of the FCC Rules . These limits are designed to provide reasonable protection. This equipment

generates , uses and can radiated radio frequency energy and , if not installed and used in accordance

with the instructions , may cause harmful interference to radio communications . However , there is no

guarantee that interference will not occur in a particular nstallation If this equipment does cause harmful

interference to radio or television reception , which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or more of the following measures:

--Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

-Reorient or relocate the receiving antenna.

Shielded interface cables must be used in order to comply with emission limits.

Changes or modifications not expressly approved by the party responsible for compliance could void the

user's authority to operate the equipment.