Owner manual

ManualsBrandsPathway ManualsControl panelDMX Relay Cabinets

Installation Instructions

Inc.

HINxxy12BC/24BC/48BC

Basic Control Lighting Panel Interior

Installation and Setup

The HINxxy12BC/24BC/48BC is the lighting

control panel interior for the Basic Control

system.

The interior provides isolation between the line- and

low-voltage sections of the panel, as well as the

mounting frame for relays, the power supply and

optional control devices.

A complete panel assembly also includes one each of

the following:

1.Tub (HTUB series)

2.Cover (HCVR series)

3.Power Supply (HPSM115/277)

Features

• From 12 to 48 plug-in relays

(Reliant Relay H2R series or GE RR series)

• Two color-coded, numbered switch/sensor termina-

tions per relay

• Mounting holes for optional control devices

• Accessory power for optional occupancy sensors

Before starting, read the instructions on the next

three pages. If you have any questions, call our

Service Team at: 888-852-2778.

Retain these instructions and the completed

WIRING SCHEDULE card in the plastic sleeve

affixed to the rear of the panel cover.

Summary of content (4 pages)

PAGE 1
The HINxxy12BC/24BC/48BC is the lighting control panel interior for the Basic Control system. The interior provides isolation between the line- and low-voltage sections of the panel, as well as the mounting frame for relays, the power supply and optional control devices. A complete panel assembly also includes one each of the following: 1. Tub (HTUB series) 2. Cover (HCVR series) 3.
PAGE 2
HINxxy12BC/24BC/48BC Lighting Control Panel Interior — Installation and Setup This interior is intended for field installation within the enclosure of another product. Refer to installation instructions INHTUB and INHCVR for installation of the Watt Stopper Tubs and Covers. The following instructions assume that a UL listed enclosure has been properly installed. Remove knockouts as required. Install relays in the frame if necessary. CAUTION: Make sure all power is off before wiring.
PAGE 3
HINxxy12BC/24BC/48BC Lighting Control Panel Interior — Installation and Setup Wiring Line voltage Figure 1 – Typical Wiring — Low-Voltage Switches Before making connections to the relays make sure that none of the load circuits are shorted or miswired. Connect the lighting circuits to the relay SPST output terminals. Wire the power supply, following the instructions which accompany the unit. Connect the ground wire to the stud provided in the tub.
PAGE 4
HINxxy12BC/24BC/48BC Lighting Control Panel Interior — Installation and Setup Relay Output Ratings CAUTION: When the panel cover is open, power to the panel must be off at all times to avoid exposure to the line-voltage wiring. If you remove the cover while the panel is powered up, use extreme caution. Do not touch any wiring, particularly outside the interior’s low-voltage barrier.