Use and Care Manual
Table Of Contents
- 幻灯片编号 1
- 幻灯片编号 2
- 幻灯片编号 3
- 幻灯片编号 4
- 幻灯片编号 5
- 幻灯片编号 6
- 幻灯片编号 7
- 幻灯片编号 8
- 幻灯片编号 9
- 幻灯片编号 10
- 幻灯片编号 11
- 幻灯片编号 12
- 幻灯片编号 13
- 幻灯片编号 14
- 幻灯片编号 15
- 幻灯片编号 16
- 幻灯片编号 17
- G-FTB-51023 GAS FIRE PIT.pdf
- GFT-10513 A GAS FIRE PIT English.pdf
- G-FTB-51023A GAS FIRE PIT English.pdf
- 空白页面
Assembly Instruction
7
Step 3:
Attach side panel with igniter (E) to right leg
(H) and right door leg(J) with four M6*12MM
bolts (L). Please use Phillips head
screwdriver (not included). Please do not
tighten any screws to the end at this step.
Pull out the control panel and attach it to side
panel with igniter (E) with four M5*10MM
bolts. Please use Phillips head screwdriver
(not included). Please do not tighten any
screws to the end at this step.
Step 2:
Attach side panel (D) to left leg (G) and right
leg (H) with four M6*12MM bolts (L), Please
use Phillips head screwdriver (not included).
Please do not tighten any screws to the end at
this step.
Attach side panel (D) to left leg (G) and left
door leg (I) with four M6*12MM bolts (L).
Please use Phillips head screwdriver (not
included). Please do not tighten any screws to
the end at this step.
Step 1:
Place table top (C) upside down on a flat,
protected surface.
Attache left leg (G), right leg (H), left door
leg( I) and right door leg ( J) to table top
(C) with four M6*12MM bolts (L). Please
use Phillips head screwdriver (not
included). Please do not tighten any screws
to then end at this step.