User's Instructions

Endura Flap Wall Mount
Installation Instructions
for single and double flap models
This package contains: Tools required:
For single flap wall mounts:
For single & double flap wall mounts:
Pencil
Drill with 3/8 inch drill bit
1 flap frame 8 hole plugs Level
1 trim frame 4 1-3/4 inch screws Jigsaw or reciprocating saw
4 2-1/4 inch screws Phillips head screwdriver
For double flap wall mounts:
4 2-3/4 inch screw
2 weather-strips
1 warranty information
2 flap frames 1 installation template
4 tunnel pieces
1 tube of silicone
WARNING: Do not cut into electrical wires under any circumstances while trying to install your Endura wall
mount pet wall. Cutting into electrical wires may result in severe injury or death. If you have any doubt in your
ability to install your new Endura wall mount pet wall, Patio Pacific strongly suggests having a fully licensed
and insured general contractor install your Endura wall mount pet wall for you.
NOTE: A minimum of 14-5/8 inches is required between studs to install the -12 Endura wall mount.
Installation Instructions
1. Tape the provided template to the wall. The top edge of
the cut-out line should be 1-1/4 inch (or more) above the
dog’s withers (shoulders) for the single flap wall mount, and
2 inches for the double flap wall mount. Be careful not to
unduly reduce the strength of the wall by cutting too close to
the bottom of the wall. Level the top edge of the cut-out line
as shown in Figure 1.
2. Mark the hole centers for the four holes and remove the
template.
3. Drill the four 3/8 inch holes as shown in Figure 2.