Manual

- 11 -
6. Wiring
Whenwiringtoexternalcontactsforthesignalline,usenon-voltagecontactssuchasarelay,switchoranNPN
(PNP type also available) open collector circuit. Refer to table 1 below for contact capacity.
Refertotable3“ContactCapacity”onthefollowingpage.
• WiringExample
•BSV-24N (NPN Transistor Type)
Power (+) White
Power
(-) Black
CH1 Sky Blue
CH2 Yellow
CH3 Peach
CH4
Light Green
Fuse Fuse
Power (+)
Power (-)
CH1
CH2
CH3
CH4
(COM) (COM)
DonotshortPower(+)totheCHlines.Failuredotosowillresultindamagetotheproduct.
NPNTransistorCircuitNon-voltageContactCircuit
* The power (-) shares the same common as the signal ground.
• Double check the wiring to prevent mistakes. Failure to conform may result in product damage, resulting
indamagetothecircuitryorre.
WARNING
• Be sure the power is disconnected before wiring or installing this product. Possibility of electric shock,
short-circuiting or product failure may occur.
• Do not pull or tug at the wires with excessive force. Failure to comply will result in damage to the product.
CAUTION