Data Sheet

-
-
-
-
channel1 - channel5 => playback
channel6 => sound reduction
channel7 =>
st
op
channel8 =>
clearance
With an input
-30dB
No Sound Reduction
-10dB
- (6) Forced Playback ON
No Sound Reduction
The sound reduction level can be selected by the channel input.
None
Sound Reduction Volume
With no input
When channels are assigned for sound reduction, STOP, and CLR, the available number of playback channels
decrease.
Using the dedicated software (PATLITE Playlist Editor 2), If a signal input is assigned with the sound reduction
function, the sound level of the message being played back will be reduced.
With no input
With an input
With an input
(Refer to "5-7. Channel Assignment Function")
-20dB
5-8. Sound Reduction
With an input
With a Forced Playback, if a signal line input occurs, the playback sound can be reduced.
Sound Reduction 2
Sound Reduction Level
With no input
With no input
- (6) When Forced Playback is OFF (the function which uses exclusive soft "PATLITE Playlist Editor 2")
The input state for sound reduction 1 and sound reduction 2 can be set up for three steps in sound reduction.
-10dB
Priority rank is channel3>channel2>channel1.
Signal Input Condition
In the Memory Playback Mode, playback is stopped and the next channel in memory is played next.
Stop
Playback
The corresponding channels are played back.
In this case, the available number of playback channels is set to five.
If simultaneous inputs for CLR and STOP occurs, priority is given to the CLR input.
The volume of sound being played back is decreased.
Example: For a maximum number of bit inputs;
In other playback modes outside memory playback, the same operation as the stop function occurs.
When two sound reduction values are set up, three sound reduction levels can be made.
Clear
A
playback input is ignored during a STOP input.
In the memory playback mode, all channels in memory is erased when an input occurs.
A
maximum of two sound reduction channels can be assigned.
Sound Reduction
In order for the sound reduction function to be used, the setup data to assign the channel has to be transmitted to
the product via an SD card.
* Fact
ory Setting : channels 1-8 are all set as "Playback".
Sound Reduction 1
The channel during playback is stopped.
If the MP3 setup mode is OFF, this function becomes invalid.
In order for the channel function assignments to be used, the setup data has to be transmitted to the product via the
SD Card.
Channel2
-30dB
-20dB
Channel3
Dedicated software (PATLITE Playlist Editor 2) can be used to assign functions to each signal input.
5-7. Channel function (Function Which Uses Exclusive Soft "PATLITE Playlist Editor 2")
(-10dB, -20dB, -30dB)
* Factory Setting: Sound Reduction Function OFF
Channel1
No.EHV-W18F-15_18