6229 W95100197 MULTI-VISUAL WARNING LIGHT ILB-L Series (Standard Type) INSTRUCTION MANUAL
Thank you for purchasing Multi Visual Revolving Warning Light. Before using the product, please read this instruction manual carefully for proper use. For maintenance, inspection and repair, be sure to read this manual. If you have any questions, do not hesitate to contact the sales offices given on the last page of this manual.
Product Warranty Provision Table of Contents Rev.1.1 This warranty provision specifies the warranty of PATLITE Corporation (hereinafter called PATLITE or we) for the products purchased from our company. ■ Product warranty In the event of a product failure under proper service conditions according to the instructions of the instruction manuals within the warranty period, we will repair the defective part or replace the product without charge to the customer.
1. Type No. Configuration 9.
3. How to Mount ②ILB-12LJAW type ( unit:mm ) 1108±5 1)Mounting with the Hook Set (Optional) 300±5 Warning ●When installing the unit, be sure to tighten the hexagon bolts (M8x50) for fixing the hook with sufficient torque. If they are not tightened enough, the unit may fall off.
4. Wiring 7.Before Requesting Service Please check the list shown below before requesting repairs. Please feel free to contact our sales offices if you have any questions concerning the product. Caution ●Before wiring, be sure to turn OFF the power supplies to the multi visual revolving warning light and the electronic siren amplifier. ●To connect a speaker, be sure to wire in accordance with the sample speaker connection diagram given in the electronic siren amplifier instruction manual.
3) Procedure for exchanging the driver unit Red 5-1 For flashing function only Ry 3 Follow the procedure below to replace the driver unit: ① Turn OFF the power (turn the switch OFF) of the multi visual revolving warning light. ② Remove the main and middle dome assemblies (see Replacing the domes on page 9). ③Loosen the four screws (nominal 5x12 round-head tapping screws) holding the joint plate in place and slide the plate (either to the left or to the right).
6. Maintenance and Inspection 2) Procedure for exchanging the LED total assembly unit (LED flashing light): Warning ●In order to keep the installation tabs secured, make sure to re-tighten the hexagon bolts on the car mounting brackets once or twice a year. Caution ●For repair, be sure to turn OFF the power supply of the multi visual revolving warning light and the electronic siren amplifier and wait until the bulb is cooled in order to prevent short circuits and burns.