Installation Instructions

ManualsBrandsPatriot Lighting Elegant Home ManualsIndoor LightingPatriot Lighting® Elegant Home Mansfield Bronze 3-Light Tiffany Island Light

THREADED TUBE

ROUGH WIRE

WIRE CONNECTOR

WHITE WIRE

GLOSSY WIRE

LOCK WASHER

OUTLET BOX SCREW

HEX NUT

BLACK WIRE

MOUNTING STRIP

GREEN GROUND SCREW

GROUND WIRE

BARE COPPER GROUNDING WIRE

CANOPY

LOOP

FINIAL

CHAIN

UPPER LOOP

LOWER LOOP

LOOP ASSEMBLY

HOOK

ARM

HOOK

LOOP DECORATIVE PART

SOCKET

SHADE

SOCKET RING

FIXTURE BODY

OUTLET BOX

FIXTURE WIRE

BARE COPPER GROUNDING WIRE

HEX NUT

ASSEMBLY INSTRUCTION SKU#: 351-4415

CONVERTIBLE ISLAND PENDANT (

WITH CHAIN OR WITHOUT CHAIN)

For Island pendant with chain Instructions:

Carefully unpack and identify each part to make sure you have everything ready for installation. Lay out each part on a clean flat area such

as a table or the carpet.

Shut down the main electrical supply from the fuse box or circuit breaker in your house or building.

3. Fasten the mounting strip onto the outlet box using 2 outlet box screws.

4. Thread the threaded tube into center hole of mounting strip about 4 complete turns. Lock in place with lock washer and hex nut. This

threaded tube should extend long enough to protrude through the canopy when it is mounted. (Adjust as needed)

5. Fasten two decorative parts to both sides of the fixture body.

6. Using a pair of pliers, twist open one chain link at the end of chain links and repeat this step for the other chain. Hook the chains to each

loop of the loop assembly and close the chain links. Place a piece of cloth between the jaws of pliers and the chain link to prevent

scratching the finish.

7. Using a pair of pliers, twist open the chain link at the other end of the chain. Hook the whole loop assembly to the loops of the canopy and

close the chain link. Place a piece of cloth between the jaws of pliers and the chain link to prevent scratching the finish.

Guide fixture wire through one arm of the loop assembly, and then hook the two arms between the lower loops and fixture loops of the

fixture body.

Weave the fixture wires up through one of the chain links, through the loop of the canopy and insert it into the canopy. Position both, the

outlet box supply wires and the fixture wires outside of the outlet box to facilitate connection.

10.

Connect the wire from the fixture to the power supply wire from the outlet box. Cover with the wire connectors.

A. Twist together the glossy / live wire from the fixture with the black wire from the outlet box. Cover with the wire connector.

B. Twist together the rough / neutral wire from the fixture with the white wire from the outlet box. Cover with the wire connector.

Note: The Glossy/Live wire has a text printed on it; the Rough/Neutral wire has a ridge.

C. The bare copper grounding wire from the fixture must loop one turn under the head of green screw on mounting strip before it is

connected to the grounding conductor of the supply circuit.

11. Carefully position all wirings inside the outlet box.

12. Place the canopy over the outlet box, let the threaded tube come through the hole of the canopy, then tighten the hex nut and finial to the

protruding threaded tube on the mounting strip until the canopy is held firmly against the ceiling.

13.

Unscrew the socket rings from the sockets. Set the glass shades onto each socket and secure using socket rings.

14.

Install the bulbs (Bulbs are not included). Use 60-watt maximum type A bulbs.

15.

Turn on the electrical power in your house or building to test the pendant lamp. Save these instructions for future use

Cleaning

● Use only a soft cloth to dust and clean your new lamp. Do not use any chemicals, polishes or abrasives.

Warning: Do not immerse your lamp in water; doing so will damage the wiring.

For Customer Service Call 1-800-388-6141 ext: 216 M – F, 9:30 a.m. to 3 p.m. EST

Light Bulb Required:

3 - 60Watt Type A

Medium Base Bulbs

Summary of content (3 pages)

PAGE 1
ASSEMBLY INSTRUCTION CONVERTIBLE ISLAND PENDANT (WITH CHAIN OR WITHOUT CHAIN) SKU#: 351-4415 For Island pendant with chain Instructions: 1. Carefully unpack and identify each part to make sure you have everything ready for installation. Lay out each part on a clean flat area such as a table or the carpet. 2. Shut down the main electrical supply from the fuse box or circuit breaker in your house or building. 3. Fasten the mounting strip onto the outlet box using 2 outlet box screws. 4.
PAGE 2
For Island pendant without chain Instructions: NOTE: Suggest contacting a qualified electrician for the following instruction. 1. Carefully unpack and identify each part to make sure you have everything ready for installation. Lay out each part on a clean flat area such as a table or the carpet. 2. Shut down the main electrical supply from the fuse box or circuit breaker in your house or building. 3. Fasten the mounting strip onto the outlet box using 2 outlet box screws. 4.
PAGE 3
PATRIOT LIGHTING® (MANSFIELD 3 LIGHT ISLAND PENDANT) WARRANTY 5-YEAR LIMITED WARRANTY: This PATRIOT LIGHTING® brand light fixture carries a five (5) Year Limited Warranty to the original purchaser. If, during normal use, this PATRIOT LIGHTING® light fixture fails due to a defect in material and workmanship within five (5) years from the date of purchase, simply bring this light fixture with your original sales receipt back to your nearest MENARDS® retail store.