Model No.
Package Contents: 2 1 4 3 6 5 9V X10 7 9 8 10 11 Unpack your fan and check the contents. You should have the following items. 1.) Hanger Bracket 2.) Canopy 3.) Canopy Cover (Comes in a separate bag) 4.) Downrod Stand Cover 5.) Downrod Set (Includes Hanger Ball, 6˝ Downrod, Hanger Pin & Lock Pin) 6.) Blade bracket Set 7.) Fan Blade (3 PCS) 8.) Fan Motor Assembly 9.) Assembly Kit 10.) Installation Instructions 11.
Exploded View Detail Hanger Bracket Hanger Ball Canopy Canopy Cover Downrod Stand Cover Downrod Lock Pin Collar Hanger Pin Fan Motor Assembly LED Strip Included Screw Set Washer Set Blade Bracket Set Blade Dual Mount Drawing Downrod Mount Slope Ceiling Mount (Up to 23 degrees) PAGE: 3 / 10 191225
Safety Instructions READ ALL SAFETY INFORMATION AND INSTALLATION INSTRUCTIONS BEFORE YOU BEGIN TO INSTALL THE FAN AND SAVE INSTRUCTIONS. All set screws of the fan must be checked and retightened where necessary before installation. To reduce the risk of personal injury, do not bend the blade brackets when installing the brackets, balancing the blades or cleaning the fan. Do not insert foreign objects between rotating fan blades.
INSTALLATION INSTRUCTIONS IMPORTANT: BEFORE YOU BEGIN INSTALLING THE FAN, CAREFULLY READ ALL INFORMATION IN THE SAFETY INSTRUCTIONS AND INSTALLATION INSTRUCTIONS. IF IN DOUBT, CONSULT A QUALIFIED ELECTRICIAN. SAVE ALL INSTRUCTIONS. NOTE: The fan weight is 15.87 lbs (7.2 kg). Be sure the outlet box you are using is securely attached to the building structure and can support the full weight of the fan. Failure to do so can result in serious injury.
Antenna Receiver There is a code switch in the transmitter and receiver. This "DIP Switch" is a 4 key unit (Fig.8). All keys were set at "ON" position in the beginning. Set the keys to a different code. Make sure the same numbered keys are switched "ON" for both DIP Switches (Fig.8a). Take note that the "ON" position may have different orientation in each. DIP Switch Fig.8a Fig.8 Code example: 1-ON 2-OFF 3-ON 4-OFF on both DIP Switches. Transmitter Fig.
Fig.11 Hanger Bracket Blade Screw Canopy Screw Washer Canopy Blade Canopy Cover Blade Bracket Set Screw Blade Bracket Set Slide the canopy up to ceiling and over the two canopy screws on hanger bracket. Rotate canopy clockwise, next, while holding the canopy with one hand, slide the canopy cover over the screws and rotate clockwise until tight. Note: Adjust the canopy screws as necessary until the canopy and canopy cover are snug. Fig.12 Fig.
Fig.17 18 Fig.19 Fig.
For a single switch Follow these steps: ck Bla e Whit White G ro Blue Connect the black (hot) wire (This is for fan control) and blue wire (This is for light control) from motor to the black (hot) wire from outlet box with a wire connector. en Gre Connect the white (neutral) wire from motor to the white (neutral) wire from the outlet box with a wire connector. un Connect three ground wires (Green or bare copper) coming from outlet box, downrod and hanging bracket with a wire connector.
Troubleshooting Guide If you have difficulty operating your new ceiling fan, it may be the result of incorrect assembly, installation or wiring. In some cases, these installation errors may be mistaken for defects. If you experience any faults, please check this Troubleshooting Guide. If a problem cannot be remedied or you are experiencing difficulty in installation, please call our Customer Service Department. PROBLEM SUGGESTED REMEDY 1. If fan does not start: 1.