Installation Instructions

SAFETY INFORMATION

Please read and understand this entire manual before attempting to assemble, operate or install the

product.

● Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing

fuse (or switching off circuit breaker).

Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit

wires to contact any surface having a sharp edge. To do so may damage or cut the wire insulation,

which could cause serious injury or death from electric shock

WARNING:

CAUTION:

●

● All electrical connections must be in agreement with local codes, ordinances or the national electric

code (NEC). Contact your municipal building department to learn about your local codes, permits

and/or inspections.

● Risk of fire – most dwellings built before 1985 have supply wire rated for 140°F/60ºC. Consult a

qualified electrician before installation.

● Do not connect this fixture to an electrical system that does not provide a means for equipment

grounding. Never use a fixture in a two-wire system that is not grounded. If you are not sure your

lighting system has a grounding means, do not attempt to install this fixture. Contact a qualified,

licensed electrician for information with regards to proper grounding methods as required by the local

electrical code in your area.

● If a dimmer control switch is used with this fixture, obtain professional advice to determine the correct

type and electrical rating required.

Before beginning assembly, installation or operation of product, make sure all parts are present. Compare

parts with package contents list and diagram on previous page. If any part is missing or damaged, do not

attempt to assemble, install or operate the product. Contact customer service for replacement parts.

Light Source

Tools Required for Assembly (not included):

: (5) 60W Type-A medium base vintage-style bulb, Alternate (5) LED bulb.

Flathead screwdriver, Phillips screwdriver, Pliers, Wire

cutters, Electrical tape, Safety goggles, Ladder.

Helpful Tools: Wire Strippers

PREPARATION

HARDWARE CONTENTS Note: Hardware not shown actual size.

Crossbar Assembly

Wire Connector

Outlet Box Screw

AA BB CC

Quick Link

Fixture Chain