Installation Instructions

ASSEMBLY INSTRUCTIONS
4
STEP 4:
a. Choose desired hanging length for the light
fixture. Suggested mounting height over a table
or island is 30 inches from the table/island top to
the bottom of the fixture.
b. Adjust the Fixture Chain (EE) to the desired
length, removing links if needed.
c. Connect one end of the Fixture Chain (EE) to the
canopy chain loop preassembled to Crossbar
Assembly (AA) with one Quick Link (DD).
d. Connect the other end of the Fixture Chain (EE)
to the fixture loop with the remaining Quick Link
(DD).
: You may need to use pliers (not included)
to open the links of Fixture Chain (EE). If so, put
a cloth over the Fixture Chain (EE) to protect the
finish from the pliers.
Suggested chain length to hang fixture 30 inches
above table top:
8’ ceiling: 11 inches or 5 inches chain + (2) Quick
links
9’ ceiling: 23 inches or 17 inches chain + (2) Quick
links
10’ ceiling: 35 inches or 29 inches chain + (2) Quick
links
11’ ceiling: 47 inches or 41 inches chain + (2) Quick
links
12’ ceiling: 59 inches or 53 inches chain + (2) Quick
links
Note
Fixture Loop
Canopy Chain Loop
DD
EE
Supply Wire
and Ground Wire
Canopy Chain Loop
DD
Fixture Loop
OR
STEP 5:
a. Confirm that the mounting height is acceptable.
Refer to STEP 4 if changes are required.
: To make the next step easier, cut the
supply wire and ground wire 12 inches longer
than the distance from the fixture loop to the
ceiling.
t: Please pay attention to the polarity
(wires labels L & N) when cutting wires. Wire
identification will be needed in STEP 7.
b. Pull the Supply Wires and Ground Wire up
through the Fixture Chain (EE) alternating links.
c. Push the ends of the supply wires and ground wire
up through the canopy chain loop and into the
outlet box. The remaining slack wire will be
pushed into the box in STEP 6.
Note
Importan