Installation Instructions

ASSEMBLY INSTRUCTIONS
STEP 7:
* Use Wire Connectors (supplied) to connect the
wires.
ground wire green ground
screw
ground screw
ground wire supply
ground
house white wire fixture
supply wire (ribbed sided)
house black (or red) wire
fixture supply wire (smooth side)
outlet box
a) Ground Wire:
1. Wrap supply around
on mounting bracket, no less than 2 in.
from the end of the wire. Tighten .
2. Connect fixture green to
wire with wire connector.
b) Supply Wire:
1. Connect the to the
from fixture identified
with the label “N”.
2. Connect the to the
from fixture
identified with the label “L”.
3. Wrap each connection with approved electrical
tape and carefully stuff all of the connected wires
into the .
WHITE OR RIBBED
BLACK (OR RED) WIRE
FROM SUPPLY
FROM SUPPLY
RIBBED SIDE OF WIRE
FIXTURE
FROM
IDENTIFIED
SMOOTH SIDE OF WIRE FROM
FIXTURE IDENTIFIED
WITH THE LABEL “N”
WITH THE LABEL “L”
GROUND WIRE
GROUND WIRE
FROM SUPPLY
FROM FIXTURE
GREEN GROUND SCREW
Canopy Lock Ring
Canopy Chain Loop
A
STEP 8:
a. Attach the ceiling canopy back over the canopy
chain loop.
b. Secure with canopy lock ring.
5
STEP 6:
a. Unthread the canopy lock ring.
b. Slide canopy lock ring and ceiling canopy (A)
down the quick link.
c. Push all slack fixture wire through canopy chain
loop and into the outlet box.
d. Trim excess fixture wire leaving a minimum of 6
inches hanging out of the outlet box.
e. Separate the smooth side and ribbed side of the
supply wire to about 3 inches from the end.
f. Using wire strippers, strip each wire ½ inch from
the end.
Supply Wire
and Ground
Wire from
Outlet Box
Canopy Lock Ring
Canopy Chain Loop
A