Installation Instructions

ManualsBrandsPatriot Lighting ManualsIndoor LightingRianto 3-Light 17.75" Diameter Brushed Nickel Convertible Semi-Flush Mount/Pendant Light

SAFETY INFORMATION

PREPARATION

ASSEMBLY INSTRUCTIONS (Drop Pentant)

Please read and understand this entire manual before attempting to assemble, operate or install the product.

WARNING

• Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or switching

off circuit breaker).

• Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact

any surface having a sharp edge. To do so may damage or cut the wire insulation, which could cause serious injury or

death from electric shock.

CAUTION

• All electrical connections must be in agreement with local codes, ordinances or the national electric code (NEC).

Contact your municipal building department to learn about your local codes, permits and/or inspections. If you do not

have electrical wiring experience, refer to a do-it-yourself wiring handbook or have your fixture installed by a qualified

licensed electrician.

• Risk of fire – most dwellings built before 1985 have supply wire rated for 140°F/60ºC. Consult a qualified electrician

before installation.

• Do not exceed the recommended wattage. Refer to the re-lamping label on the light socket for maximum wattage.

• Do not replace a bulb when electrical outlet switch is turned to the “ON” position.

• Do not immerse your lamp in water; doing so will damage the wire.

• Keep materials that burn easily away from lighted bulbs.

Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts with

package contents list and diagram on previous page. If any part is missing or damaged, do not attempt to assemble,

install or operate the product. Contact customer service for replacement parts.

Tools Required for Assembly (not included): Screwdriver, Phillips Screwdriver, Pliers, Electrical Tape, Wire Cutters, Safety

Glasses, Ladder, Wire Stripper.

1. Fasten the mounting bracket

(AA) onto the outlet box using two

outlet box screws (short) (BB).

Screw the threaded tube (DD) into

the mounting bracket (AA), and

secure it using the lock washer

(EE) and hex nut (FF). Note:

The threaded tube (DD) should

extend long enough to protrude

through the canopy (JJ) when it is

mounted. (Adjust as needed).

3. Guide fixture wire through the

loop (LL) and fasten the loop (LL)

into canopy (A).

Note: Do not twist the fixture wire.

4. Adjust three arms to make an

equal distance between arms as

shown.

6. Unscrew the ring (HH) from the

screw collar loop (GG), and lower

the canopy (JJ) and ring (HH)

over the chain (KK) on the fixture.

Weave the fixture wires and bare

copper ground wire up through the

chain (KK), ring (HH), canopy (JJ),

screw collar loop (GG), threaded

tube (DD), and then into the outlet

box.

2. Place the canopy (JJ) over the

threaded tube (DD), and screw the

screw collar loop (GG) onto the

threaded tube (DD). Secure the

canopy (JJ) using the ring (HH).

5. Adjust the chain (KK) to the

desired height by opening the last

link of the chain (KK). Use a pair

of pliers and a screwdriver. Wrap

a soft cloth around the pliers to

protect the chain’s finish. Attach

one end of the chain (KK) onto

the screw collar loop (GG) and the

other end onto the loop (LL).