Installation Instructions

Canopy
Standard or
Closemount
Angled
Mount
Set Screw
Downrod
Downrod
Clip
Downrod Pin
Mounting Bracket
Screws
Mounting Bracket
Mounting
Bracket
5
ASSEMBLY INSTRUCTIONS
3
2
1
1. Turn OFF the electrical power at the main fuse or circuit
breaker.
2. Loosen all four preassembled mounting bracket
screws, then completely remove the two mounting
bracket screws from the round holes of canopy. Set
aside for later use.
Detach mounting bracket from canopy.
4
3. Attach mounting bracket to outlet box (not included)
using screws and washers provided with the outlet box.
CAUTION: It is very important to use the proper hardware
when installing the mounting bracket as this will support
the fan.
4. Remove the downrod clip and downrod pin from the
downrod. Then partially loosen the two set screws in the
yoke at the top of the motor assembly.