Installation Instructions
6
ASSEMBLY INSTRUCTIONS
7
6
5
7. Insert blade through slot in the side of the motor
assembly. Align the holes of one blade with three blade
screw holes in underside of the motor assembly. Secure
blade with three blade screws and blade washers.
Repeat for the remaining blades.
8. Remove one of the three adapter plate screws
preassembled to the adapter plate and loosen the other
two but do not remove.
8
Mounting
Bracket
Blade Washer
Adapter Plate
Adapter Plate Screw
Blade Screw
Blade
Light Kit
Mounting
Bracket
Screw
6. Slide the top of the motor assembly over the
mounting bracket, aligning the slotted holes in the
top of the motor assembly with the pre-loosened
mounting bracket screws in the mounting bracket.
Twist the canopy clockwise to lock. Then, re-insert
the mounting bracket screws and securely tighten all
screws.
5. Connect supply and fan wires according to the diagram
and these steps:
• Connect the Green wire from the mounting bracket to
the Bare/Green (ground) supply wire.
• Connect the White wire from the fan to the White
(neutral) supply wire.
• Connect the Black wire from the fan to the Black (hot)
supply wire.
Secure all wiring connections together with wire
connectors.
Note: The Black wire is hot power. The White wire is
neutral. The Green wire is the ground wire. If supply wires
are dierent colors than referred to above, a professional
electrician should determine the proper wiring.
Black (Hot)
White (Neutral)
Bare/Green (Ground)
Green
Black
White
Warning: Do NOT use a
full-range dimmer switch to
control the fan speed.
Wire Connector