Installation Instructions

D CFL
LEARN
2
OPERATING INSTRUCTIONS
1
2. Remove battery door from back o the remote to
access the following:
D/CFL Switch - set to “D” at the factory. The switch should
remain in the “D” position to ensure the LED is dimmable.
LEARN - Syncs remote to receiver (see troubleshooting
for instructions).
2
1. To operate the fan using the remote from remote pack,
press and release the following buttons:
III - High speed
II - Medium speed
I - Low speed
Fan O - Turns power to fan o.
Light Delay - Tap the light delay button, which will turn
o the light after one minute. Tap the light control button
to exit light delay mode.
Light Control - Tap the light control button to turn the
light o and on. Press and hold light control button to dim
or brighten the lights.
Reverse Switch - located on remote.
In warmer weather, push the reverse switch left toward sun
icon, which will result in downward airow creating a wind
chill eect.
In cooler weather, push the reverse switch right toward the
snowake icon, which will result in upward airow that
can help move hot air o the ceiling.
Important: Wait for the fan to stop before moving
the seasonal slide switch. The reverse switch must be
set either completely left or right in order for the fan
to function correctly. If the switch is set in the middle
position, the fan will not operate.
LED Indicator - LED Indicator will ash for one minute as a
reminder to replace the 12-volt battery.
Battery Compartment
(battery door removed)
9
High Speed
LED Indicator
Medium Speed
Low Speed
Fan O
Learn
D/CFL
Light Delay
Light Control
Reverse Switch