Installation Instructions

Page 3 of 4
ASSEMBLY INSTRUCTIONS FOR PENDANT(contiuned)
10. Turn on the power at the main fuse or circuit
breaker box.
9. Hook one end of the suspension
rods to the loop-2, and then
hook the other end of the
suspension rods to the loop-3.
Note: Make sure all the three
suspension rods hook tightly
each loop-2 and loop-3 one
by one.
9
ASSEMBLY INSTRUCTIONS (For SEMI-FLUSH)
Turn off the power at fuse or circuit box.
7. Install 3 x 100W Max .Medium Base
Bulbs (not included).
Bulb Type A
Max.100W
(not included)
7
8
A
8. Attach the glass shade (B) to the glass
bracket by threading set screws on to
the glass notches. (Do not over tighten.)
AA
CC
6. Connect the smooth wire to black wire
(power), the ribbed wire to white wire
(neutral) with the wire connector(CC)
provided. Connect the copper wire on the
light fixture to the mounting strap(AA) by
securing it with the preinstalled grounding
screw, and then connect it to the house
grounding wire with wire connector(CC).
Carefully put all the wires into outlet box.
6
2. Follow step 2 as For Pendant.
1. Attach the mounting bracket
(AA) to the outlet box by using
two mounting screws(BB).
1
10
B
BB
AA
Hook
Metal Ring
Loop-3
Loop-2
Glass shade
11
3. Remove the canopy from the stem
of the fixture. Then slip the canopy
through the nipple, secure it with
washer and hex nut.
A
FF
12
5. Attach the fixture canopy(A) to the
mounting strap, and secure it with
the ball nuts(FF).
13
4. Pull out the source wires from the outlet
box. Make wire connections using wire
connectors as follows:
• Connect the hot wires (usually black
insulation) from the fixture to the black
wire from the power source.
• Connect the neutral wires (usually
white insulation) from the fixture to the
white wire from the power source.
• Attach the fixture grounding wire (usually bare wire) to
the mounting bracket (AA) with the green grounding screw
(DD), and then connect them to the house grounding
wire with the wire connector (CC).
Carefully put the wires back into the outlet box.
CC
14
6.Install 3x 100W Max. Medium Base
Bulbs (not included).
15
16
7. Attach the glass shade (B) to the
metal ring by threading set screws
onto the glass notches. (Do not
over tighten.)
Glass shade
Bulb Type A Max. 100W
(not included)
9. Turn on the power at the main fuse or circuit
breaker box.
8. Hook one end of the suspension
rods to the loop-2, and then
hook the other end of the
suspension rods to the loop-3.
Note: Make sure all the three
suspension rods hook tightly
each loop-2 and loop-3 one
by one.
Hook
Metal Ring
Loop-3
Loop-2
AA
DD