Installation Instructions

3
Turn off circuit breakers and wall switch to the fixture
supply line leads.
WARNING: Failure to disconnect power supply prior to
installation may result in serious injury.
ON
OFF
ON
OFF
ASSEMBLY INSTRUCTIONS
Unscrew decorative nuts (CC) and remove mounting strap (AA) from
canopy (A). Save decorative nuts for later use.
NOTE: Do not remove screws (BB) or nuts (DD) from mounting strap
(AA).
2.
3.
Remove existing fixture.
WARNING: When using an existing outlet box, be sure the outlet box
is securely attached to the building structure and can support the full
weight of the fixture. Failure to do so can result in serious injury.
4.
1.
5.
If you wish to use the fixture with two rods (B), gently slide the middle
rod (B) up over the wiring and discard. Thread wires through rods (B)
and canopy.
If you wish to use the fixture with all three rods (B), secure rods (B)
by screwing the ends of each one together. Pull wires completely
through top of canopy (A). Be sure rods (B) are secure.
Attach mounting strap (AA) to outlet box (not included) using the
existing screws and washers or the mounting screws (FF)
provided in hardware pack.
Outlet Box
Washer
AA
AA DD
BB
CC
Wiring
Wiring
Wire Strippers
Wire Knot
C
B
B
B
B
6.
Prepare wire by stripping 3/4 inch of insulation from wire ends using wire
strippers (not included). Tie wire into a knot.
A
FF