Installation Instructions

FUNCTION AND OPERATION (continued)
Page 5 of 7
Sensitivity of Motion Sensor
The sensitivity of the motion sensor can be adjusted by using the “Sens” knob located on the right side of the panel at
the back of sensor lens (See Fig.10). To increase sensitivity, turn the knob clockwise. To decrease sensitivity, turn the
knob counterclockwise. The sensitivity may be adjusted from a minimum of 5 feet to a maximum of 40 feet.
NOTE:
1. The sensitivity of the motion sensor will increase as the
environmental temperature gets cooler. For best performance,
gently clean the lens with a soft cloth every 1 or 2 months to
assure maximum sensitivity.
2. For best performance, install fixture at least 6 feet above
the ground. At such a height, the fixture will provide a
detection distance of up to 40 feet at 77 degrees
Fahrenheit. (See Fig.11)
3.The sensor detects across a detection range of 180 degrees.
(See Fig.12)
4. The sensor will be more sensitive to motion across its
detection path than motion directly towards it. (See Fig.13)
5. To reduce possible nuisances, do not mount the fixture
near a heat source like an air conditioner, vent or furnace
exhaust, or in a direction facing any reflecting object or
other light source.
5`
6`
10`
40`
Where you install your lantern is important:
Be sure the light is mounted straight on the wall;
otherwise, the detection distance may be limited.
Fig.11
Fig. 12
180˚
Motion
Least sensitive
Motion
Most sensitive
Sensor
Fig. 13
Assembly Kit
4549MM (2 SET)
Assembly Kit
5923AA (2 SET)
Assembly Kit
5924MM (2 SET)
The following parts are available for re-order if damaged or missing. Call us toll-free at 1-800-887-6326
AA
BB
DD
EE
FF
GGE
CC
Mounting Screw
X2
Wire Connector
X3
Lock Nut
X4
Ball Nut
X2
Rubber Pad
X2
Cross Bar
X1
Headless Screw
X2
Spare Parts List:
Glass Shade
X2
(9348FC)
Finial
Decorated Cup Rubber Pad
Hex Nut Washer
Finial