Installation Instructions

Page 6 of 7
TROUBLESHOOTING
CARE AND MAINTENANCE
● To clean, turn off and wipe with a damp, non-abrasive cloth.
If the light does not work at all:First check the following aspects
1. Make sure the wall switch and circuit breaker are on.
2. Make sure the wiring is correct.
3. Make sure the bulb is not burned out，or loose
use bleow chart for troubleshooting your security light
If unable to fix any of the above issues, please consult a certified electrician.
During the first installation, need to test product
function in the test mode.
Night
Confirm that light is on after cover the sensor by
hand, move another dark position.and avoid direct
sunlight.
Slide the switch to Auto mode.
The product may be installed in a
dark position, or it is shielded from
the sun.
After strong light on the sensor for over 5 seconds,
if it goes out,replace the install position or remove
the object
Ensure that the product is not detected.
Time delay accumulates under test
model.
A sudden or artificial power break
within 3 seconds, entering the
manual override mode.
Turn off the power, the initial setting will be restored
after more than 5 seconds.
False triggering caused by a heat
source, such as a heater or dryer vent,
or heated
swimming pool.
Eliminate heat source or relocate fixture.
In the Off / Auto mode, the sensor
has been measured to move the
object,and the high level delay time
is superimposed.
Ensure that no long-term moving objects around
the product.
In the PC mode.
Slide the switch to Off / Auto mode.
The switch is not slid into the position
of any model.
Slide it again to the model you want.
Light bulb quality or matching
problem.
It is normal to replace incandescent lamp instead of
confirming function nomally, otherwise change the
bulb.
If the light will
not come on
Day
Night
If the light
flashes or
blinks
Night
SYMPTOM
DAY/NIGHT
POSSIBLE CAUSE
SOLUTION
Day
Test product functionality not in test
mode.
It is possible to install where there
is bright light.
In the off mode,When the motion
stops, the light will remain on for
the predetermined time set
(5 ~ 180 seconds), then the light
will turn off automatically.
On cloudy or overcast days,the light
may stay on longer than anticipation.
No corrective action needed.
If the light
stays on
There are passing cars and reflective
objects that interfere with the sensor.
Replace the installed position.