Installation Instructions

ManualsBrandsPatriot Lighting ManualsIndoor LightingChantelle Matte Black 3-Light Pendant

SAFETY INFORMATION

PREPARATION

ASSEMBLY INSTRUCTIONS

Please read and understand this entire manual before attempting to assemble, operate or install the product.

WARNING

• Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or switching off

circuit breaker).

• Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact any

surface having a sharp edge. To do so may damage or cut the wire insulation, which could cause serious injury or death from

electric shock.

CAUTION

• All electrical connections must be in agreement with local codes, ordinances or the national electric code (NEC). Contact

your municipal building department to learn about your local codes, permits and/or inspections. If you do not have electrical

wiring experience, refer to a do-it-yourself wiring handbook or have your fixture installed by a qualified licensed electrician.

• Risk of fire – most dwellings built before 1985 have supply wire rated for 140°F/60ºC. Consult a qualified electrician before

installation.

• Do not exceed the recommended wattage. Refer to the re-lamping label on the light socket for maximum wattage.

• Do not replace a bulb when electrical outlet switch is turned to the “ON” position.

• Do not immerse your lamp in water; doing so will damage the wire.

• Keep materials that burn easily away from lighted bulbs.

Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts with package

contents list and diagram on previous page. If any part is missing or damaged, do not attempt to assemble, install or operate the

product. Contact customer service for replacement parts.

Tools required for assembly (not included): screwdriver, phillips screwdriver, pliers, electrical tape, wire cutters, safety glasses,

ladder, wire stripper.

1. Fasten the mounting strip

(AA) onto the outlet box

using 2 outlet box screws

(BB). Screw the threaded

tube (DD) into the mounting

strip (AA). Using the lock

washer (EE) and hex nut

(FF), secure the threaded

tube (DD) in place. This

threaded tube (DD) should

extend long enough to

protrude through the

canopy when it is mounted.

(Adjust as needed).

2. Place the canopy (GG)

over the threaded tube

(DD) and screw the screw

collar loop (HH) onto the

threaded tube (DD). Then

secure with the ring (II).

1 2

3. Adjust three lower arms

of the fixuture body (B) to

make an equal distance

between arms as shown

4. Unscrew the

thumbscrews (OO) from the

cap of the top the fixture

body (B) and loosen the cap

nuts (NN) from the arms of

the fixture body (B). Align

the hole of the arms (C) with

the hole of the cap of the top

of the fixture body (B) and

tighten the arms (C) to the

cap with thumbscrews (OO).

Adjust as needed to align

the arms. Then secure the

cap nuts (NN).

Tighten the

hanging loop (A) onto the

fixture body (B).

3 4