LIMITED LIFETIME WARRANTY To obtain Service, please contact PATRIOT LIGHTING® Service Department: 1-800-887-6326, 9 a.m.5 p.m. central time. Model No.
Package Contents — 7 RAA DG | | Estimate [Smsgmgm 9 ! O Gaza | ! Fund Goth | i Quid God | 5= magma Unpack your fan and check the contents. You should have the following items. 1.) Mounting Bracket 2.) Hang Motor Assembly 3.) Housing 4.) Fan Light Kit 5.) Glass Shade 6.) Blade Bracket (§ PCS) 7.) Fan Blade (5 PCS) 8.) Switch Box Cover 9.) Assembly Kit 10.) Installation Instructions 11.) 9W E26 (M) Base A19 Type LED Bulb (PCS) Dimension Reference: B | A B.&" R/ patriot PAGE: 2/9 LIGHTING.
Exploded View Detail Mounting Bracket Mounting Bar Hang Motor Assembly Housing Blade Becket@ Blade Fan Light LED Light Bulb Glass Shade Metal Pad Rubber Pad End Cap Finial Hex Nut T “Patriot LIGHTING.
Safety Instructions READ ALL SAFETY INFORMATION AND INSTALLATION INSTRUCTIONS BEFORE YOU BEGIN TO INSTALL THE FAN AND SAVE INSTRUCTIONS. ®All set screws of the fan must be checked and re tightened where necessary before installation. @ To reduce the risk of personal injury, do not bend the blade brackets when installing the brackets, balancing the blades or cleaning the fan. Do not insert foreign objects between rotating fan blades.
INSTALLATION INSTRUCTIONS IMPORTANT: ® BEFORE YOU BEGIN INSTALLATION, CAREFULLY READ ALL INFORMATION PROVIDED ON THE SAFETY INSTRUCTIONS AND INSTALLATION INSTRUCTIONS. IF IN DOUBT, CONSULT A QUALIFIED ELECTRICIAN. ® SAVE ALL INSTRUCTIONS. NOTE: The fan weight Is 13.67 Ibs (6.2 kg. Be sure the outlet box you are using Is securely attached to the bulling structure and can support the full weight of the fan. Failure to do so can result in serious injury.
=] For a single switch B Follow these steps: & [Connect the whits (neutral) [wire from motor to the white oo zillion e o g connector. [wires (Green or bare (copper) coming from loutish bax, hang motor assembly with a wire connector. [Connect the back (hot) wire (This is for fan control) and bite [wire: (This Is for light control) farm Motor to the back (hot) wire from loutish box with a wire connector.
Mounting Bracket Decorative Housing ‘Screw & Lack Washer The decorative housing has two mating slots and two mating holes. Palpation both slots on the decorative housing directly under and In line with two screws and washers in the mounting bracket. Lift the decorative housing, allowing the two screws and washers to slide into the mating slots. Rotate the decorative housing counterclockwise until both screws from the mounting bracket drop into the slot recesses. Tighten screws securely.
=™ Adjust the glass shade and cap direction, make sure that the —Metal Pad Rubber Pad—— "1 ——Hex Nut End Cap Finlay v Install the glass shade, rubber washer and metal washer upward hole of glass shade and the knob through the threaded pipe and secure with hex nut. Then attach of the switch box are lined up perpendicularly.
Trouble Shooting Guide If you have difficulty operating your new ceiling fan, it may be the result of incorrect assembly, installation or wiring. If you experience any faults, please check this Trouble Shooting Guide. If a problem cannot be remedied or you are experiencing difficulty in installation, please call our Customer Service Department (1-800-887-6326). PROBLEM SUGGESTED REMEDY 1. If fan does not start 1. Check main and branch circuit fuses or circuit breakers. 2.