SDS

ManualsBrandsPatriot Lighting ManualsLandscape LightingSolar Integrated LED Butterfly on Jar Landscape Light

Page 5/11

Safety Data Sheet

1907/2006/EC, 1272/2008/EC

Printing date 01.03.2016 Revision: 01.03.2016

Trade name: NI-MH RECHARGEABLE BATTERY

(Contd. of page 4)

42.0.11

MAK (Germany) vgl.Abschn.IIb

VME (France) Long-term value: 2 mg/m³

7782-42-5 Graphite (2,6%)

AGW (Germany) Long-term value: 1,25* 10** mg/m³

2(II);*alveolengängig**einatembar; AGS, DFG

VME (France) Long-term value: 2 mg/m³

pour la fraction alvéolaire

DNELs:

Not available

PNECs:

Not available

Additional information:

The lists valid during the making were used as basis.

8.2 Exposure controls

Based on the composition shown in Section 3, the following measures are suggested for occupational safety

measure.

Appropriate engineering controls:

Keep away from foodstuffs, beverages and feed.

Immediately remove all soiled and contaminated clothing

Wash hands before breaks and at the end of work.

Store protective clothing separately.

Avoid contact with the eyes.

Avoid contact with the eyes and skin.

See Section 7 for information about design of technical facilities.

Personal protective equipment

Respiratory protection:

In case of brief exposure or low pollution use respiratory filter device. In case of intensive or longer exposure

use self-contained respiratory protective device.

Protection of hands:

Protective gloves

The glove material has to be impermeable and resistant to the product/ the substance/ the preparation.

Due to missing tests no recommendation to the glove material can be given for the product/ the preparation/

the chemical mixture.

Selection of the glove material on consideration of the penetration times, rates of diffusion and the

degradation

Material of gloves

The selection of the suitable gloves does not only depend on the material, but also on further marks of quality

and varies from manufacturer to manufacturer. As the product is a preparation of several substances, the

resistance of the glove material can not be calculated in advance and has therefore to be checked prior to the

application.

Penetration time of glove material:

The exact break through time has to be found out by the manufacturer of the protective gloves and has to be

observed.

Eye protection:

Tightly sealed goggles

Environmental exposure controls:

Control measures must be made in accordance with Community environmental protection legislation.

(Contd. on page 6)