Assembly Instructions

Page 2 of 4
210605
Please read and understand this entire manual before attempting to assemble, operate or install the product.
WARNING
● Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or
switching off circuit breaker).
● Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact
any surface having a sharp edge. To do so may damage or cut the wire insulation, which could cause serious injury
or death from electric shock.
CAUTION
● All electrical connections must be in agreement with local codes, ordinances or the national electric code (NEC).
Contact your municipal building department to learn about your local codes, permits and/or inspections.
● Risk of fire – most dwellings built before 1985 have supply wire rated for 140°F/60ºC. Consult a qualified electrician
before installation.
● Do not connect this fixture to an electrical system that does not provide a means for equipment grounding. Never use
a fixture in a two-wire system that is not grounded. If you are not sure your lighting system has a grounding means,
do not attempt to install this fixture. Contact a qualified, licensed electrician for information with regards to proper
grounding methods as required by the local electrical code in your area.
PREPARATION
Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts with
package contents list and diagram on previous page. If any part is missing or damaged, do not attempt to assemble,
install or operate the product. Contact customer service for replacement parts.
Tools Required for Assembly (not included): Slotted Screwdriver, Phillips Screwdriver, Pliers, Electrical Tape, Wire
Cutters, Safety Glasses, Ladder, Wire Stripper.
ASSEMBLY INSTRUCTIONS
SAFETY INFORMATION
2. Rod connections:
a.
Secure the bottom rod onto the
fixture(B) using the threaded
pipe.
b. Thread the fixture wire through
the lower rod, then secure the
lower rod onto the bottom rod
using the threaded pipe.
c. Thread the fixture wire through
the middle rod, then secure the
middle rod onto the lower rod
using the threaded pipe.
d. Thread the fixture wire through
the upper rod, then secure the
upper rod onto the middle rod
using the threaded pipe.
d. Thread the fixture wire through
the fixture loop, then secure the
fixture loop onto the upper rod.
Note: The height can be adjusted to 44-7/8" by using
the rods. Use fewer rods if shorter height is desired.
2
Bottom Rod
1. Attach mounting strap
unit(AA) to outlet box by
using two mounting
screws(BB).
Note: The depth of
threaded pipe on the
mounting strap unit may
need to be adjusted to
properly fit the fixture.
Turn off the power at the fuse or circuit box.
1
AA
BB
Lower Rod
（9-1/2")
Middle Rod
（9-1/2")
Upper Rod
（9-1/2")
Fixture Loop
B