Installation Instructions

ManualsBrandsPatriot Lighting ManualsLighting & Ceiling FansSterling Forged Bronze Outdoor Flush Mount Ceiling Light

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT

BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.

NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. Customer Service: 1-800-887-6326 (weekdays 9 a.m. – 5 p.m. CST)

3. READ AND SAVE THESE INSTRUCTIONS.

356-4826

1. Attach the two long screws to the mounting strap, and screw in 2 to 3 turns.

2. Attach the mounting strap to the outlet box using two short mounting screws.

3. Pull out the outlet wires and the house grounding wire from the outlet box. Make wire connections using the

wire nuts:

---The two black wires from the fixture to the black wire from the power source.

---The two white wires from the fixture to the white wire from the power source.

---Attach the fixture grounding wire to the mounting strap with the green grounding screw. Then connect it to

the house grounding wire with the wire nut.

Carefully put the wires back into the outlet box.

4. Attach the ceiling pan to the mounting strap by inserting two long screws into the key holes, and rotate

the pan until it locks in place. Then secure the screws tightly. (See Fig.1)

CAUTION: With silicone caulking compound, caulk completely around where the back side of the main frame

meets with the ceiling surface to prevent water from seeping into the outlet box.

5. Install bulbs (not included). See relamping label at socket area or packaging for maximum allowed wattage.

6. Place the bottom glass panel into the metal frame, and set the eight "S" clips on the slot and fix the bottom

glass panel by inserting the side glass panels onto the “S”clips. Then press the top clips of the metal frame to

secure the side glass panels. (See Fig 2. / Fig 3. / Fig 4.)

7. Attach the metal frame to the ceiling pan by locating the “L” slot in the screws, then turn it clockwise until

it locks in place.

8. Turn on the power at the main fuse or circuit breaker box.

111021

Ceiling Pan

Socket

Bulb Type A Max. 60W

(not included)

Screw

“L” Slot

Metal Frame

Outlet Box

House Grounding Wire

Wire Nut

Long Screw

Mounting Strap

Green Grounding Screw

Short Mounting Screw

Fig.1

Long Screw

Key Hole

Contents of Spare Parts:

Assembly Kit

(1 SET)

(4365MM)

Bottom Glass Panel

(1 PC)

(9246S)

Side Glass Panel

(8 PCS)

(9245S)

“S＂Clip

(8 PCS)

(4378CC)

Side Glass panel

“S” Clip

Bottom Glass panel

Top Clip

Fig.4

Fig.2

Metal Stop

Fig.3

“S” Clip

Slot

Summary of content (2 pages)

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS 356-4826 WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. Customer Service: 1-800-887-6326 (weekdays 9 a.m. – 5 p.m. CST) 3. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
5-YEAR LIMITED WARRANTY: This Patriot Lighting fixture carries a limited warranty against defects in material or workmanship. If the Patriot Lighting product fails at any time within five (5) years after the original date of sale due to defects in material or workmanship, return the product to Menards with the original sales receipt. At its discretion, Patriot Lighting will replace the defective fixture with the same or similar fixture or issue a refund.