Installation Instructions

ManualsBrandsPatriot Lighting ManualsLighting & Ceiling FansAvis Noble Bronze Outdoor Wall Light

1. Take a glass panel and gently slide it up into the fixture in place,

secure it by pressing the cilps from both top and bottom sides. (

See Fig. 1 ) Repead with other panels.

2. Thread two headless screws to the cross bar, and secure them

with four lock nuts (two on each side of the mounting plate).

Adjust the length of the headless screws if necessary.

3. Attach the cross bar to the outlet box by using two mounting screws.

4. Pull out the outlet wires and the house grounding wire from the

outlet box. Make wire connections using the wire nuts:

---Connect the black wire from the fixture to the black wire from the power source.

---Connect the white wire from the fixture to the white wire from the power source.

---Attach the fixture grounding wire to the cross bar with the green grounding screw. Then connect it to the

house grounding wire with a wire nut.

Carefully put the wires back into the outlet box.

5. Attach the back plate to the cross bar by inserting the headless screws, then secure it with two rubber pads

and ball nuts.

CAUTION: With silicone caulking compound, caulk completely around where the back plate meets

with the wall surface to prevent water from seeping into the outlet box.

House Grounding Wire

Green Grounding Screw

Fixture Grounding Wire

Wire Nut

Mounting Screw

Headless Screw

Outlet Box

Fixture Wire

Lock Nut

Back Plate

Ball Nut

Fixture

Bulb Type B Max.60W

(not included)

Contents of Spare Parts:

Assembly Kit

(1 SET)

(4382MM)

Cross Bar

Rubber Pads

Patriot Lighting

111026

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT

BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.

NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. Customer Service: 1-800-887-6326 (weekdays 8 a.m. – 5 p.m. CST)

3. READ AND SAVE THESE INSTRUCTIONS.

356-4881

Glass Panel

Fig.1

Glass Panel

(4 PCS)

(9254S)

Threaded pipe

Bottom Cover

Finial

Curved Arm

Fixture

Clips

Glass Panel

Ball Nut

(2 PCS)

(4382BB)

Finial

(1 PC)

(4382FF)

Bottom Cover

(1 PC)

(4382BC)

Curved Arm

(1 PC)

(4382BA)

Threaded Pipe

(1 PC)

(4382NP)

Coupling

Pipe Coupling

Summary of content (2 pages)

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS 356-4881 WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. Customer Service: 1-800-887-6326 (weekdays 8 a.m. – 5 p.m. CST) 3. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
6. Install bulbs (not included). See relamping label at socket area or packaging for maximum allowed wattage. 7. Screw the threaded pipe into the coupling, attach the bottom cover to the fixture by inserting the threaded pipe, then attach one end of the curved arm into the pipe coupling, slide the other end up to the bottom cover, and secure it with finial. 8. Turn on the power at the main fuse or circuit breaker box.